8 material differences · fewer than 12
Tractor oneALLIS-CHALMERS 1851970–1981No measured PTO figureTractor twoSOMECA 750 (TD)1971–1976No measured PTO figure
Which should you choose?
Read our verdict on the 185 and the 750 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 185 | 750 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74.0 hp | 74.0 hp | — |
| Engine declared | ALLIS-CHALMERS D-2800 | O.M.-FIAT CO 3/70 | differs |
| Displacement declared | 4.93 L | 4.56 L | +8% 185 |
| Maximum torque declared | — | 206 lb·ft · 279 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 14.9 mph · 24 km/h | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 20.0 gpm · 75.7 L/min | 7.3 gpm · 27.5 L/min | +175% 185 |
| Rear PTO speeds declared | 540 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,699 lb · 3,946 kg | 6,713 lb · 3,045 kg | +30% 185 |
| Wheelbase declared | 99.2 in · 2,519 mm | 96.1 in · 2,440 mm | — |
| Length declared | 158.0 in · 4,013 mm | 153.9 in · 3,910 mm | — |
| Width declared | 76.5 in · 1,943 mm | 72.0 in · 1,830 mm | +6% 185 |
| Ground clearance declared | 20.5 in · 521 mm | 20.5 in · 520 mm | — |
| Turning radius, braked declared | 10.2 ft · 3.12 m | 12.5 ft · 3.80 m | +22% 750 (TD) |
| Fuel tank declared | 98.3 qt · 93.0 L | 85.6 qt · 81.0 L | +15% 185 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS 185 sources
- Source: Traktorenlexikon, “Allis-Chalmers 185”
- Source: Traktorenlexikon, “Allis-Chalmers 180”
SOMECA 750 (TD) sources
- Source: Traktorenlexikon, “Someca 750”