9 material differences · fewer than 12
Tractor oneALLIS-CHALMERS 1751973–1980No measured PTO figureTractor twoFord 5000 (A)1964–1975No measured PTO figure
Which should you choose?
Read our verdict on the 175 and the 5000 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 175 | 5000 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 60.9 hp | 61.2 hp | — |
| Engine declared | Perkins 4236 | Ford ND 2.508 E or 2.514 E | differs |
| Displacement declared | 3.86 L | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 12.4–17.4 mph · 20–28 km/h | differs |
| Clutch declared | — | Pedal-operated dry BORG & BECK single-plate clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 6.5 gpm · 24.6 L/min | 6.1 gpm · 23.2 L/min | +6% 175 |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,800 lb · 3,538 kg | 5,553 lb · 2,519 kg | +40% 175 |
| Wheelbase declared | 93.0–95.5 in · 2,362–2,426 mm | 87.5 in · 2,223 mm | differs |
| Length declared | 136.5 in · 3,467 mm | 142.9 in · 3,630 mm | — |
| Width declared | 76.6 in · 1,946 mm | 68.1–96.1 in · 1,730–2,440 mm | differs |
| Ground clearance declared | 21.5 in · 546 mm | 15.5 in · 394 mm | +39% 175 |
| Turning radius, braked declared | 10.2 ft · 3.10 m | 11.1 ft · 3.38 m | +9% 5000 (A) |
| Fuel tank declared | 74.0 qt · 70.0 L | 79.8 qt · 75.5 L | +8% 5000 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS 175 sources
- Source: Traktorenlexikon, “Allis-Chalmers 175”
- Source: Traktorenlexikon, “Lindner BF 650 SN/SA”
Ford 5000 (A) sources
- Source: Traktorenlexikon, “Ford 5000”