AGRIFULL 80-60 (DT) or SAME Condor 55 (DT)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 80-60 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Condor 55 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for AGRIFULL 80-60 (DT) and SAME Condor 55 (DT), with the call on each
Question80-60 (DT)Condor 55 (DT)Call
Which puts more power through the PTO shaft?41.2 kW (55.3 hp)Traktorenlexikon, “Agrifull 80-60”40.5 kW (54.3 hp)Traktorenlexikon, “SAME Condor 55 (DT)”Not comparableNot comparable on power at the PTO shaft: the 80-60 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Condor 55 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 80-60 (DT) and the Condor 55 (DT).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 80-60 (DT) and the Condor 55 (DT).
Which pumps more oil for implements?22.0 L/min (5.8 gpm)Traktorenlexikon, “Agrifull 80-60”24.0 L/min (6.3 gpm)Traktorenlexikon, “SAME Condor 55 (DT)”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?1,580 kg (3,483 lb)Traktorenlexikon, “SAME Condor 55 (DT)”No figureNo call on three-point lift: no figure on record for the 80-60 (DT).
Which is heavier, for traction?2,590 kg (5,710 lb)Traktorenlexikon, “Agrifull 80-60”1,980 kg (4,365 lb)Traktorenlexikon, “SAME Condor 55 (DT)”Ahead (a fact, not an advantage)The AGRIFULL 80-60 (DT) is 31% heavier (610 kg / 1,345 lb) than the SAME Condor 55 (DT) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 80-60 (DT) and the Condor 55 (DT).
Which has the wider choice of gears?12Traktorenlexikon, “Agrifull 80-60”8 to 14Traktorenlexikon, “SAME Condor 55 (DT)”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 80-60 (DT) and the Condor 55 (DT).
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “Agrifull 80-60”25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “SAME Condor 55 (DT)”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Agrifull 80-60”540 rpmTraktorenlexikon, “SAME Condor 55 (DT)”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Agrifull 80-60”independentTraktorenlexikon, “SAME Condor 55 (DT)”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Agrifull 80-60”Two-wheel or four-wheel driveTraktorenlexikon, “SAME Condor 55 (DT)”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1980–19861982–1983EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The AGRIFULL 80-60 (DT) is 31% heavier (610 kg / 1,345 lb) than the SAME Condor 55 (DT) (both unladen weight, as stated by the source).
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Even on PTO independence: every PTO is independent.
  • Even on drive: every machine is available with four-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the 80-60 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Condor 55 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources