10 material differences · fewer than 12
Tractor oneAGRIFULL 80-60 (DT)1980–1986No measured PTO figureTractor twoFord 4130 (A)1990–1996No measured PTO figure
Which should you choose?
Read our verdict on the 80-60 (DT) and the 4130 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 80-60 (DT) | 4130 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 55.3 hp | 55.3 hp | — |
| Engine declared | V.M.-MOTTORI 1053 SU | Ford K 201 CID-NA | differs |
| Displacement declared | 2.86 L | 3.29 L | +15% 4130 (A) |
| Maximum torque declared | 127 lb·ft · 172 N·m | 143 lb·ft · 194 N·m | +13% 4130 (A) |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Dry Valeo or LuK dual clutch | Pedal operated dry AP single-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 5.8 gpm · 22.0 L/min | 9.3 gpm · 35.3 L/min | +60% 4130 (A) |
| Pressure declared | — | 1,378–1,450 psi · 95–100 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,710 lb · 2,590 kg | 6,155 lb · 2,792 kg | +8% 4130 (A) |
| Wheelbase declared | 85.8 in · 2,180 mm | 84.5 in · 2,146 mm | — |
| Length declared | 137.8 in · 3,500 mm | 138.6 in · 3,521 mm | — |
| Width declared | 76.0 in · 1,930 mm | 69.7–96.7 in · 1,771–2,457 mm | differs |
| Ground clearance declared | 16.5 in · 420 mm | 13.9 in · 353 mm | +19% 80-60 (DT) |
| Turning radius, braked declared | 12.5 ft · 3.80 m | — | — |
| Fuel tank declared | 84.5 qt · 80.0 L | 69.4 qt · 65.7 L | +22% 80-60 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGRIFULL 80-60 (DT) sources
- Source: Traktorenlexikon, “Agrifull 80-60”
Ford 4130 (A) sources
- Source: Traktorenlexikon, “Ford 4130”