8 material differences · fewer than 12
Tractor oneAGRIFULL 80-60 (DT)1980–1986No measured PTO figureTractor twoEicher 3056 S1982–1990No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 2WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 80-60 (DT) | 3056 S | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 55.3 hp | 55 hp | — |
| Engine declared | V.M.-MOTTORI 1053 SU | Eicher EDL 3-8 | differs |
| Displacement declared | 2.86 L | 2.93 L | — |
| Maximum torque declared | 127 lb·ft · 172 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5–24.9 mph · 25–40 km/h | differs |
| Clutch declared | Dry Valeo or LuK dual clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 5.8 gpm · 22.0 L/min | 6.6 gpm · 25 L/min | +14% 3056 S |
| Pressure declared | — | 3,046 psi · 210 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm / 750 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,710 lb · 2,590 kg | 6,801 lb · 3,085 kg | +19% 3056 S |
| Maximum permissible mass declared | — | 8,818 lb · 4,000 kg | — |
| Wheelbase declared | 85.8 in · 2,180 mm | 95.5 in · 2,425 mm | +11% 3056 S |
| Length declared | 137.8 in · 3,500 mm | 139.0 in · 3,530 mm | — |
| Width declared | 76.0 in · 1,930 mm | 78.5 in · 1,995 mm | — |
| Ground clearance declared | 16.5 in · 420 mm | 19.9 in · 505 mm | +20% 3056 S |
| Turning radius, braked declared | 12.5 ft · 3.80 m | 12.5 ft · 3.80 m | — |
| Fuel tank declared | 84.5 qt · 80.0 L | 103.6 qt · 98 L | +23% 3056 S |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGRIFULL 80-60 (DT) sources
- Source: Traktorenlexikon, “Agrifull 80-60”
Eicher 3056 S sources
- Source: Traktorenlexikon, “Eicher 3056”
- Source: Traktorenlexikon, “Eicher 656 PA”