AGRIFULL 80-50 (DT) or WHITE 2-50?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 80-50 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2-50 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The WHITE 2-50 suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for AGRIFULL 80-50 (DT) and WHITE 2-50, with the call on each
Question80-50 (DT)2-50Call
Which puts more power through the PTO shaft?35.3 kW (47.3 hp)Traktorenlexikon, “Agrifull 80-50”35.3 kW (47.3 hp)Traktorenlexikon, “White 2-50”Not comparableNot comparable on power at the PTO shaft: the 80-50 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2-50 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 80-50 (DT) and the 2-50.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 80-50 (DT) and the 2-50.
Which pumps more oil for implements?22.0 L/min (5.8 gpm)Traktorenlexikon, “Agrifull 80-50”22.7 L/min (6.0 gpm)Traktorenlexikon, “White 2-50”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?1,351 kg (2,978 lb)Traktorenlexikon, “Agrifull 80-50”952 kg (2,099 lb)Traktorenlexikon, “White 2-50”Not comparableNot comparable on three-point lift: the 80-50 (DT): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Agrifull 80-50”); the 2-50: lift through the full range 610 mm behind the ends, as stated by the source (Traktorenlexikon, “White 2-50”) — not the same quantity, basis and condition.
Which is heavier, for traction?1,790 kg (3,946 lb)Traktorenlexikon, “Agrifull 80-50”1,859 kg (4,098 lb)Traktorenlexikon, “White 2-50”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 80-50 (DT) and the 2-50.
Which has the wider choice of gears?9Traktorenlexikon, “Agrifull 80-50”8 to 12Traktorenlexikon, “White 2-50”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 80-50 (DT) and the 2-50.
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “Agrifull 80-50”30 km/h (18.6 mph)Traktorenlexikon, “White 2-50”AheadThe WHITE 2-50 has 20% more top speed (5.0 km/h / 3.1 mph) than the AGRIFULL 80-50 (DT) (both top speed forward, as stated by the source).
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Agrifull 80-50”540 rpmTraktorenlexikon, “White 2-50”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Agrifull 80-50”independentTraktorenlexikon, “White 2-50”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Agrifull 80-50”Two-wheel or four-wheel driveTraktorenlexikon, “White 2-50”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1981–19861976–1980Ahead (a fact, not an advantage)The AGRIFULL 80-50 (DT) is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The WHITE 2-50 has 20% more top speed (5.0 km/h / 3.1 mph) than the AGRIFULL 80-50 (DT) (both top speed forward, as stated by the source).
  • The AGRIFULL 80-50 (DT) is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Even on PTO independence: every PTO is independent.
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on power at the PTO shaft: the 80-50 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2-50 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • Not comparable on three-point lift: the 80-50 (DT): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Agrifull 80-50”); the 2-50: lift through the full range 610 mm behind the ends, as stated by the source (Traktorenlexikon, “White 2-50”) — not the same quantity, basis and condition.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources