7 material differences · fewer than 12
Tractor oneAGRIFULL 80-50 (DT)1981–1986No measured PTO figureTractor twoSOMECA 460 (TD)1980No measured PTO figure
Which should you choose?
Read our verdict on the 80-50 (DT) and the 460 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 8 fields identical or within 5%, which is not counted as material
| Field | 80-50 (DT) | 460 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47.3 hp | 47.3 hp | — |
| Engine declared | FIAT 8035.00 | FIAT-IVECO 8035.01.300 | differs |
| Displacement declared | 2.34 L | 2.34 L | — |
| Maximum torque declared | 110 lb·ft · 149 N·m | 110 lb·ft · 149 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | dry VALEO or LuK double clutch type 11/11 inches | Dry FEREDO double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 5.8 gpm · 22.0 L/min | 7.1 gpm · 26.8 L/min | +22% 460 (TD) |
| Pressure declared | 3,118 psi · 215 bar | 2,843 psi · 196 bar | +10% 80-50 (DT) |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,946 lb · 1,790 kg | 3,990 lb · 1,810 kg | — |
| Wheelbase declared | 77.6 in · 1,970 mm | 76.9 in · 1,953 mm | — |
| Length declared | 141.7 in · 3,600 mm | 127.3 in · 3,233 mm | +11% 80-50 (DT) |
| Width declared | 63.0–86.6 in · 1,600–2,200 mm | 60.2–87.8 in · 1,530–2,230 mm | — |
| Ground clearance declared | 15.0 in · 380 mm | 17.9 in · 455 mm | +20% 460 (TD) |
| Turning radius, braked declared | — | 10.2 ft · 3.10 m | — |
| Fuel tank declared | 52.8 qt · 50.0 L | 57.1 qt · 54.0 L | +8% 460 (TD) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGRIFULL 80-50 (DT) sources
- Source: Traktorenlexikon, “Agrifull 80-50”
SOMECA 460 (TD) sources
- Source: Traktorenlexikon, “Someca 460”
- Source: Traktorenlexikon, “Someca 450 N”