9 material differences · fewer than 12
Tractor oneAGRIFULL 55 (DT)1987–1991No measured PTO figureTractor twoSAME Explorer 55 (DT)1983–1986No measured PTO figure
Which should you choose?
Read our verdict on the 55 (DT) and the Explorer 55 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 55 (DT) | Explorer 55 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 54.3 hp | 54.3 hp | — |
| Engine declared | FIAT-IVECO 8035.06 | SAME 916.3 A | differs |
| Displacement declared | 2.71 L | 2.75 L | — |
| Maximum torque declared | 130 lb·ft · 176 N·m | 131 lb·ft · 177 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 7.1 gpm · 26.8 L/min | 7.7 gpm · 29.0 L/min | +8% Explorer 55 (DT) |
| Pressure declared | 3,118 psi · 215 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,431 lb · 2,010 kg | 5,600 lb · 2,540 kg | +26% Explorer 55 (DT) |
| Wheelbase declared | 80.8 in · 2,052 mm | 86.4 in · 2,195 mm | +7% Explorer 55 (DT) |
| Length declared | 126.0 in · 3,200 mm | 138.6 in · 3,520 mm | +10% Explorer 55 (DT) |
| Width declared | 60.6 in · 1,540 mm | 72.0–95.6 in · 1,828–2,428 mm | differs |
| Ground clearance declared | 19.5 in · 495 mm | 17.1 in · 435 mm | +14% 55 (DT) |
| Turning radius, braked declared | 11.8 ft · 3.60 m | 11.0 ft · 3.35 m | +7% 55 (DT) |
| Fuel tank declared | 64.5 qt · 61.0 L | 70.8 qt · 67.0 L | +10% Explorer 55 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGRIFULL 55 (DT) sources
- Source: Traktorenlexikon, “Agrifull 55”
- Source: Traktorenlexikon, “Fiat 50-66/50-66 DT”
SAME Explorer 55 (DT) sources
- Source: Traktorenlexikon, “SAME Explorer 55”