5 material differences · fewer than 12
Tractor oneAgco RT-110 A2007–2011No measured PTO figureTractor twoSteyr 4130 Expertfrom 2019No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2007–2011; 2019–2019). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | RT-110 A | 4130 Expert | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 131.2 hp | 129 hp | — |
| Engine declared | SISU-DIESEL 66 CTA-4V | — | — |
| Displacement declared | 6.60 L | — | — |
| Maximum torque declared | 445 lb·ft · 604 N·m | — | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9 mph · 40 km/h | — |
| Clutch declared | Pedal-actuated electrohydraulic VALEO multi-plate clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 27.2 gpm · 102.8 L/min | 29.1 gpm · 110 L/min | +7% 4130 Expert |
| Pressure declared | 3,336 psi · 230 bar | 2,901 psi · 200 bar | +15% RT-110 A |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 12,200 lb · 5,534 kg | 12,125 lb · 5,500 kg | — |
| Wheelbase declared | 111.3 in · 2,827 mm | 98.0 in · 2,490 mm | +14% RT-110 A |
| Length declared | 183.3 in · 4,656 mm | 188.3 in · 4,784 mm | — |
| Width declared | 79.3–100.4 in · 2,014–2,550 mm | 87.7 in · 2,228 mm | differs |
| Ground clearance declared | 16.9 in · 430 mm | — | — |
| Fuel tank declared | 412.1 qt · 390.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco RT-110 A sources
- Source: Traktorenlexikon, “AGCO RT 110 A”
- Source: Traktorenlexikon, “AGCO RT 100 A”
Steyr 4130 Expert sources
- Source: Traktorenlexikon, “Steyr 4130 Expert”