7 material differences · fewer than 12
Tractor oneAgco RT-100 (Traktorenlexikon)2004–2005No measured PTO figureTractor twoNew Holland 81601996–1999No measured PTO figure
Which should you choose?
Read our verdict on the RT-100 and the 8160 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | RT-100 | 8160 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 98.6 hp | 98.6 hp | — |
| Engine declared | CUMMINS 6 BTA 6.7 | NEW HOLLAND 675-TC | differs |
| Displacement declared | 6.83 L | 7.48 L | +9% 8160 |
| Maximum torque declared | 311 lb·ft · 422 N·m | 297 lb·ft · 403 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 33.7 gpm · 127.4 L/min | 26.3 gpm · 99.6 L/min | +28% RT-100 |
| Pressure declared | 3,336 psi · 230 bar | 2,408–2,582 psi · 166–178 bar | differs |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 15,223 lb · 6,905 kg | 11,574 lb · 5,250 kg | +32% RT-100 |
| Maximum permissible mass declared | — | 16,535 lb · 7,500 kg | — |
| Wheelbase declared | 109.4 in · 2,780 mm | 107.2 in · 2,723 mm | — |
| Length declared | 183.9 in · 4,670 mm | 179.5 in · 4,560 mm | — |
| Width declared | 88.6 in · 2,250 mm | 92.5 in · 2,350 mm | — |
| Ground clearance declared | 14.6 in · 370 mm | 14.2 in · 360 mm | — |
| Fuel tank declared | 317.0 qt · 300.0 L | 232.5 qt · 220.0 L | +36% RT-100 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco RT-100 (Traktorenlexikon) sources
Source
- Source: Traktorenlexikon, “AGCO RT 100”
New Holland 8160 sources
Source
- Source: Traktorenlexikon, “New Holland 8160”