Agco GT-75 or Deutz-Fahr Agroplus 87?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the GT-75 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Agroplus 87 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Deutz-Fahr Agroplus 87 suits loader and hydraulic implement work better on this data: 22% (9.7 L/min / 2.6 gpm) more hydraulic flow.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | GT-75 | Agroplus 87 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 61 kW (82 hp)Traktorenlexikon, “AGCO GT 75” | 61.1 kW (81.9 hp)Traktorenlexikon, “Deutz-Fahr Agroplus 87” | Not comparableNot comparable on power at the PTO shaft: the GT-75 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Agroplus 87 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the GT-75 and the Agroplus 87. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the GT-75 and the Agroplus 87. |
| Which pumps more oil for implements? | 44.3 L/min (11.7 gpm)Traktorenlexikon, “AGCO GT 75” | 54.0 L/min (14.3 gpm)Traktorenlexikon, “Deutz-Fahr Agroplus 87” | AheadThe Deutz-Fahr Agroplus 87 has 22% more hydraulic flow (9.7 L/min / 2.6 gpm) than the Agco GT-75 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | — | 3,000 kg (6,614 lb)Traktorenlexikon, “Deutz-Fahr Agroplus 87” | No figureNo call on three-point lift: no figure on record for the GT-75. |
| Which is heavier, for traction? | 2,739 kg (6,038 lb)Traktorenlexikon, “AGCO GT 75” | 2,700 kg (5,952 lb)Traktorenlexikon, “Deutz-Fahr Agroplus 87” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | — | 4,500 kg (9,921 lb)Traktorenlexikon, “Deutz-Fahr Agroplus 87” | No figureNo call on maximum permissible mass: no figure on record for the GT-75. |
| Which has the wider choice of gears? | 16Traktorenlexikon, “AGCO GT 75” | 20Traktorenlexikon, “Deutz-Fahr Agroplus 87” | EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the GT-75 and the Agroplus 87. |
| Which is faster on the road? | 40 km/h (24.9 mph)Traktorenlexikon, “AGCO GT 75” | 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr Agroplus 87” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540 rpm / 1000 rpmTraktorenlexikon, “AGCO GT 75” | 540 rpm / 1000 rpmTraktorenlexikon, “Deutz-Fahr Agroplus 87” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | — | independentTraktorenlexikon, “Deutz-Fahr Agroplus 87” | No figureNo call on PTO independence: not stated for the GT-75. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “AGCO GT 75” | 2WD / 4WDTraktorenlexikon, “Deutz-Fahr Agroplus 87” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 2004–2007 | 2006–2009 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Deutz-Fahr Agroplus 87 has 22% more hydraulic flow (9.7 L/min / 2.6 gpm) than the Agco GT-75 (both pump flow, as stated by the source).
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the GT-75 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Agroplus 87 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources