7 material differences · fewer than 12
Tractor oneAgco GT-552004–2007No measured PTO figureTractor twoLamborghini Crono-Target 70 (DT)2005–2009No measured PTO figure
Which should you choose?
Read our verdict on the GT-55 and the Crono-Target 70 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | GT-55 | Crono-Target 70 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 66.1 hp | 66.1 hp | — |
| Engine declared | SAME-DEUTZ-FAHR 1000.3 WT 3-E | S.D.F. 1000.3 WT (EURO-II) | differs |
| Displacement declared | 3.00 L | 3.00 L | — |
| Maximum torque declared | 184 lb·ft · 250 N·m | 192 lb·ft · 260 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Pedal-operated dry Lamborghini single-plate clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 12.5 gpm · 47.3 L/min | — | — |
| Pressure declared | 3,118 psi · 215 bar | 3,046 psi · 210 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/540E rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,509 lb · 2,499 kg | 4,564 lb · 2,070 kg | +21% GT-55 |
| Wheelbase declared | 82.9 in · 2,105 mm | 82.9 in · 2,105 mm | — |
| Length declared | 146.5 in · 3,720 mm | 128.7 in · 3,270 mm | +14% GT-55 |
| Width declared | 75.6–87.8 in · 1,920–2,230 mm | 70.1–85.8 in · 1,780–2,180 mm | differs |
| Ground clearance declared | 17.5 in · 445 mm | 17.5 in · 445 mm | — |
| Turning radius, braked declared | 10.0 ft · 3.06 m | — | — |
| Fuel tank declared | 94.8 qt · 89.7 L | 52.8 qt · 50.0 L | +79% GT-55 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco GT-55 sources
- Source: Traktorenlexikon, “AGCO GT 55”
Lamborghini Crono-Target 70 (DT) sources
- Source: Traktorenlexikon, “Lamborghini CRONO Target 70”