5 material differences · fewer than 12
Tractor oneAgco GT-552004–2007No measured PTO figureTractor twoDeutz-Fahr Agroplus 672006–2009No measured PTO figure
Which should you choose?
Read our verdict on the GT-55 and the Agroplus 67 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 9 fields identical or within 5%, which is not counted as material
| Field | GT-55 | Agroplus 67 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 66.1 hp | 66.1 hp | — |
| Engine declared | SAME-DEUTZ-FAHR 1000.3 WT 3-E | SLH 1.000.3 WT | differs |
| Displacement declared | 3.00 L | 3.00 L | — |
| Maximum torque declared | 184 lb·ft · 250 N·m | 192 lb·ft · 260 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9 mph · 40 km/h | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 12.5 gpm · 47.3 L/min | 14.3 gpm · 54.0 L/min | +14% Agroplus 67 |
| Pressure declared | 3,118 psi · 215 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,509 lb · 2,499 kg | 5,732 lb · 2,600 kg | — |
| Maximum permissible mass declared | — | 9,921 lb · 4,500 kg | — |
| Wheelbase declared | 82.9 in · 2,105 mm | 82.9 in · 2,105 mm | — |
| Length declared | 146.5 in · 3,720 mm | 135.0 in · 3,430 mm | +8% GT-55 |
| Width declared | 75.6–87.8 in · 1,920–2,230 mm | 82.7 in · 2,100 mm | differs |
| Ground clearance declared | 17.5 in · 445 mm | 16.7 in · 425 mm | — |
| Turning radius, braked declared | 10.0 ft · 3.06 m | — | — |
| Fuel tank declared | 94.8 qt · 89.7 L | 95.1 qt · 90 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco GT-55 sources
- Source: Traktorenlexikon, “AGCO GT 55”
Deutz-Fahr Agroplus 67 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 67”