Agco DT-250 B vs John Deere 8295 R
6 material differences · fewer than 12
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Tracks); the 8295 R is on tracks, not an alternative to an ordinary tractor. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | DT-250 B | 8295 R | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 286.0 hp | 291 hp | — |
| Engine declared | SISU-DIESEL 84 CTA-4V | — | — |
| Displacement declared | 8.42 L | — | — |
| Maximum torque declared | — | 966 lb·ft · 1,310 N·m | — |
| Transmission | |||
| Top speed declared | 24.9–31.1 mph · 40–50 km/h | 31.1 mph · 50 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Closed centre | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 27.9 gpm · 105.5 L/min | — | — |
| Pressure declared | 3,336 psi · 230 bar | — | — |
| Three-point lift at ends declared | 24,595 lb · 11,156 kg | — | — |
| Rear PTO speeds declared | 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 25,838 lb · 11,720 kg | 27,448 lb · 12,450 kg | +6% 8295 R |
| Wheelbase declared | 122.2 in · 3,105 mm | 118.9 in · 3,020 mm | — |
| Length declared | 215.7 in · 5,479 mm | 220.1 in · 5,590 mm | — |
| Width declared | 79.3 in · 2,014 mm | 97.6 in · 2,480 mm | +23% 8295 R |
| Height declared | 141.0 in · 3,581 mm | 120.5 in · 3,060 mm | +17% DT-250 B |
| Ground clearance declared | 18.5 in · 470 mm | — | — |
| Turning radius, braked declared | 24.3 ft · 7.40 m | — | — |
| Fuel tank declared | 623.4 qt · 590.0 L | 719.6 qt · 681 L | +15% 8295 R |
Agco DT-250 B sources
Source
- Source: Traktorenlexikon, “AGCO DT 250 B”
- Source: Traktorenlexikon, “AGCO DT 205 B”
John Deere 8295 R sources
Source
- Source: Traktorenlexikon, “John Deere 8295 R”
- Source: OECD test report 2616