Agco DT-240 A vs John Deere 7290R
4 material differences · fewer than 12
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2005–2008; 2014–2014). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
4 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | DT-240 A | 7290R | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 286.0 hp | 308 hp | +8% 7290R |
| Engine declared | SISU-DIESEL 84 ETA | — | — |
| Displacement declared | 8.42 L | — | — |
| Maximum torque declared | 814 lb·ft · 1,103 N·m | 963 lb·ft · 1,305 N·m | +18% 7290R |
| Transmission | |||
| Top speed declared | 24.9–31.1 mph · 40–50 km/h | 24.9–31.1 mph · 40–50 km/h | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Closed centre | — |
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 36.9 gpm · 139.8 L/min | 42.8 gpm · 162 L/min | +16% 7290R |
| Three-point lift at ends declared | 14,648 lb · 6,644 kg | — | — |
| Rear PTO speeds declared | 540/1000/540E rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 20,371 lb · 9,240 kg | 23,845 lb · 10,816 kg | +17% 7290R |
| Maximum permissible mass declared | 30,865 lb · 14,000 kg | — | — |
| Wheelbase declared | 121.1 in · 3,075 mm | 115.2 in · 2,925 mm | — |
| Length declared | 209.4 in · 5,320 mm | 207.8 in · 5,278 mm | — |
| Width declared | 100.4 in · 2,550 mm | 100.2 in · 2,544 mm | — |
| Height declared | 125.2 in · 3,180 mm | 130.4 in · 3,313 mm | — |
| Ground clearance declared | 19.7 in · 500 mm | — | — |
| Fuel tank declared | 697.4 qt · 660.0 L | — | — |
Agco DT-240 A sources
Source
- Source: Traktorenlexikon, “AGCO DT 240 A”
- Source: Traktorenlexikon, “AGCO DT 220 A”
John Deere 7290R sources
Source
- Source: Traktorenlexikon, “John Deere 7290 R”
- Source: OECD test report 2851, 2014
- Source: OECD test report 2847, 2014