10 material differences · fewer than 12
Tractor oneAgco DT-2252002–2004No measured PTO figureTractor twoFendt Favorit 824 LSE1993–2004No measured PTO figure
Which should you choose?
Read our verdict on the DT-225 and the Favorit 824 LSE → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | DT-225 | Favorit 824 LSE | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 224.9 hp | 227 hp | — |
| Engine declared | CUMMINS CTA-8.3 | MAN D 0826 LE 523 | differs |
| Displacement declared | 8.27 L | 6.87 L | +20% DT-225 |
| Maximum torque declared | 677 lb·ft · 918 N·m | 698 lb·ft · 947 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 31.1 mph · 50 km/h | +25% Favorit 824 LSE |
| Clutch declared | Pedal-operated wet multi-disc clutch | wet multi-plate driving clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 29.9 gpm · 113.2 L/min | 26.9 gpm · 102.0 L/min | +11% DT-225 |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 19,745 lb · 8,956 kg | 17,196–18,188 lb · 7,800–8,250 kg | differs |
| Maximum permissible mass declared | — | 26,455 lb · 12,000 kg | — |
| Wheelbase declared | 121.0 in · 3,073 mm | 111.8 in · 2,840 mm | +8% DT-225 |
| Length declared | 203.0 in · 5,156 mm | 194.5 in · 4,940 mm | — |
| Width declared | 98.2 in · 2,494 mm | 102.0 in · 2,590 mm | — |
| Ground clearance declared | 16.9 in · 430 mm | 23.8 in · 605 mm | +41% Favorit 824 LSE |
| Turning radius, braked declared | — | 17.7 ft · 5.40 m | — |
| Fuel tank declared | 479.7 qt · 454.0 L | 391.0 qt · 370 L | +23% DT-225 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-225 sources
- Source: Traktorenlexikon, “AGCO DT 225”
- Source: Traktorenlexikon, “AGCO DT 180”
Fendt Favorit 824 LSE sources
- Source: Traktorenlexikon, “Fendt Favorit 824”