9 material differences · fewer than 12
Tractor oneAgco DT-225 B2009–2010No measured PTO figureTractor twoDeutz-Fahr Agrotron 8280 TTVfrom 2020No measured PTO figure
Which should you choose?
Read our verdict on the DT-225 B and the Agrotron 8280 TTV → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | DT-225 B | Agrotron 8280 TTV | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 261.4 hp | 264 hp | — |
| Engine declared | SISU-DIESEL 84 CTA-4V | Deutz AG TTCD 6.1 L6 (Agri) | differs |
| Displacement declared | 8.42 L | 6.06 L | +39% DT-225 B |
| Maximum torque declared | — | 904 lb·ft · 1,226 N·m | — |
| Transmission | |||
| Top speed declared | 24.9–31.1 mph · 40–50 km/h | 24.9–37.3 mph · 40–60 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 27.9 gpm · 105.5 L/min | — | — |
| Pressure declared | 3,336 psi · 230 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 25,838 lb · 11,720 kg | 20,790–23,645 lb · 9,430–10,725 kg | differs |
| Maximum permissible mass declared | — | 35,274 lb · 16,000 kg | — |
| Wheelbase declared | 122.2 in · 3,105 mm | 114.9 in · 2,918 mm | +6% DT-225 B |
| Length declared | 215.7 in · 5,479 mm | 191.6–238.8 in · 4,867–6,065 mm | differs |
| Width declared | 79.3 in · 2,014 mm | 100.4–117.7 in · 2,550–2,990 mm | differs |
| Ground clearance declared | 18.5 in · 470 mm | 17.7–20.1 in · 450–510 mm | differs |
| Turning radius, braked declared | 24.3 ft · 7.40 m | — | — |
| Fuel tank declared | 623.4 qt · 590.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-225 B sources
- Source: Traktorenlexikon, “AGCO DT 225 B”
- Source: Traktorenlexikon, “AGCO DT 205 B”
Deutz-Fahr Agrotron 8280 TTV sources
- Source: Traktorenlexikon, “Deutz-Fahr 8280 TTV”