10 material differences · fewer than 12
Tractor oneAgco DT-200 A2005–2008No measured PTO figureTractor twoFendt 724 Variofrom 2011No measured PTO figure
Which should you choose?
Read our verdict on the DT-200 A and the 724 Vario → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | DT-200 A | 724 Vario | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 231.7 hp | 233 hp | — |
| Engine declared | SISU-DIESEL 74 ETA | Deutz TCD 6.1 L6 | differs |
| Displacement declared | 7.37 L | 6.06 L | +22% DT-200 A |
| Maximum torque declared | 682 lb·ft · 924 N·m | 780 lb·ft · 1,058 N·m | +15% 724 Vario |
| Transmission | |||
| Top speed declared | 24.9–31.1 mph · 40–50 km/h | 31.1 mph · 50 km/h | differs |
| Clutch declared | — | PTO multi-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | Load sensing | — |
| Pump flow declared | 37.4 gpm · 141.5 L/min | — | — |
| Pressure declared | 3,336 psi · 230 bar | — | — |
| Rear PTO speeds declared | 540/1000/540E rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 19,136 lb · 8,680 kg | 17,417 lb · 7,900 kg | +10% DT-200 A |
| Maximum permissible mass declared | 30,865 lb · 14,000 kg | 27,558 lb · 12,500 kg | +12% DT-200 A |
| Wheelbase declared | 121.1 in · 3,075 mm | 109.6 in · 2,783 mm | +10% DT-200 A |
| Length declared | 206.3 in · 5,240 mm | 206.3 in · 5,240 mm | — |
| Width declared | 100.4 in · 2,550 mm | 100.4 in · 2,550 mm | — |
| Ground clearance declared | 19.7 in · 500 mm | 21.7 in · 552 mm | +10% 724 Vario |
| Fuel tank declared | 697.4 qt · 660.0 L | 422.7 qt · 400 L | +65% DT-200 A |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-200 A sources
- Source: Traktorenlexikon, “AGCO DT 200 A”
- Source: Traktorenlexikon, “AGCO DT 180 A”
Fendt 724 Vario sources
- Source: Traktorenlexikon, “Fendt 724 Vario”
- Source: Traktorenlexikon, “Fendt 819 Vario”