10 material differences · fewer than 12
Tractor oneAgco DT-1802002–2004No measured PTO figureTractor twoDeutz-Fahr Agrotron 6190from 2013No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (33%); they were not built in overlapping years (2002–2004; 2013–2013). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | DT-180 | Agrotron 6190 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 179.6 hp | 181 hp | — |
| Engine declared | CUMMINS CTA-8.3 | Deutz AG TCD 6.1 L06 4V | differs |
| Displacement declared | 8.27 L | 6.06 L | +37% DT-180 |
| Maximum torque declared | 633 lb·ft · 858 N·m | 605 lb·ft · 820 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | Pedal-operated wet VALEO multi-plate clutch | Electro-hydraulically operated multi-plate clutch, running in an oil bath | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 30.3 gpm · 114.7 L/min | 21.9 gpm · 83 L/min | +38% DT-180 |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 19,484 lb · 8,838 kg | 14,683 lb · 6,660 kg | +33% DT-180 |
| Wheelbase declared | 121.0 in · 3,073 mm | 108.9 in · 2,767 mm | +11% DT-180 |
| Length declared | 203.0 in · 5,156 mm | 189.2 in · 4,806 mm | +7% DT-180 |
| Width declared | 98.2 in · 2,494 mm | 98.4 in · 2,500 mm | — |
| Ground clearance declared | 18.0 in · 457 mm | — | — |
| Fuel tank declared | 479.7 qt · 454.0 L | 264.2 qt · 250 L | +82% DT-180 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-180 sources
- Source: Traktorenlexikon, “AGCO DT 180”
Deutz-Fahr Agrotron 6190 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 6190”
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 7250”