Agco DT-180 A or New Holland T 7060?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the DT-180 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the T 7060 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The New Holland T 7060 suits loader and hydraulic implement work better on this data: 30% (2,003 kg / 4,416 lb) more three-point lift.
- The Agco DT-180 A suits road haulage better on this data: 17% (2,000 kg / 4,409 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | DT-180 A | T 7060 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 158.1 kW (212.0 hp)Traktorenlexikon, “AGCO DT 180 A” | 156.7 kW (210.1 hp)Traktorenlexikon, “New Holland T7060 Power Command” | Not comparableNot comparable on power at the PTO shaft: the DT-180 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the T 7060 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the DT-180 A and the T 7060. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the DT-180 A and the T 7060. |
| Which pumps more oil for implements? | 141.5 L/min (37.4 gpm)Traktorenlexikon, “AGCO DT 180 A” | — | No figureNo call on hydraulic flow: no figure on record for the T 7060. |
| Which lifts more on the three-point hitch? | 6,644 kg (14,648 lb)Traktorenlexikon, “AGCO DT 180 A” | 8,647 kg (19,063 lb)Traktorenlexikon, “New Holland T7060 Power Command” | AheadThe New Holland T 7060 has 30% more lift (2,003 kg / 4,416 lb) than the Agco DT-180 A (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 9,030 kg (19,908 lb)Traktorenlexikon, “AGCO DT 180 A” | 8,200 kg (18,078 lb)Traktorenlexikon, “New Holland T7060 Power Command” | Ahead (a fact, not an advantage)The Agco DT-180 A is 10% heavier (830 kg / 1,830 lb) than the New Holland T 7060 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 14,000 kg (30,865 lb)Traktorenlexikon, “AGCO DT 180 A” | 12,000 kg (26,455 lb)Traktorenlexikon, “New Holland T7060 Power Command” | AheadThe Agco DT-180 A has 17% higher maximum permissible mass (2,000 kg / 4,409 lb) than the New Holland T 7060 (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | Stepless (CVT)Traktorenlexikon, “AGCO DT 180 A” | 18 to 19 forwardTraktorenlexikon, “New Holland T7060 Power Command” | DifferTransmissions differ in kind: the Agco DT-180 A is stepless (CVT) and the New Holland T 7060 has 18 to 19 forward gears — not called. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the DT-180 A and the T 7060. |
| Which is faster on the road? | 40 km/h (24.9 mph) to 50 km/h (31.1 mph)Traktorenlexikon, “AGCO DT 180 A” | 40 km/h (24.9 mph) to 50 km/h (31.1 mph)Traktorenlexikon, “New Holland T7060 Power Command” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000/540E rpmTraktorenlexikon, “AGCO DT 180 A” | 540/540E/1000 rpmTraktorenlexikon, “New Holland T7060 Power Command” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | — | — | No figureNo call on PTO independence: not stated for the DT-180 A and the T 7060. |
| Which drives on both axles? | 4WDTraktorenlexikon, “AGCO DT 180 A” | 4WDTraktorenlexikon, “New Holland T7060 Power Command” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 2005–2008 | 2007–2011 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The New Holland T 7060 has 30% more lift (2,003 kg / 4,416 lb) than the Agco DT-180 A (both lift at the hitch ends, as stated by the source).
- The Agco DT-180 A is 10% heavier (830 kg / 1,830 lb) than the New Holland T 7060 (both unladen weight, as stated by the source).
- The Agco DT-180 A has 17% higher maximum permissible mass (2,000 kg / 4,409 lb) than the New Holland T 7060 (both maximum permissible mass, as stated by the source).
- Transmissions differ in kind: the Agco DT-180 A is stepless (CVT) and the New Holland T 7060 has 18 to 19 forward gears — not called.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the DT-180 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the T 7060 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources