10 material differences · fewer than 12
Tractor oneAgco DT-180 A2005–2008No measured PTO figureTractor twoCase-IH Puma 2102007–2011No measured PTO figure
Which should you choose?
Read our verdict on the DT-180 A and the Puma 210 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | DT-180 A | Puma 210 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 212.0 hp | 210.1 hp | — |
| Engine declared | SISU-DIESEL 74 ETA | IVECO-NEF 667 TA | differs |
| Displacement declared | 7.37 L | 6.73 L | +9% DT-180 A |
| Maximum torque declared | 645 lb·ft · 875 N·m | 622 lb·ft · 843 N·m | — |
| Transmission | |||
| Top speed declared | 24.9–31.1 mph · 40–50 km/h | 24.9–31.1 mph · 40–50 km/h | — |
| Clutch declared | Electro-hydraulically operated wet multi-disc PTO clutch | Electro-hydraulically operated wet Case-New-Holland multi-disc driving clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Closed centre | — |
| Hydraulic control declared | Load sensing | Load sensing | — |
| Pump flow declared | 37.4 gpm · 141.5 L/min | — | — |
| Pressure declared | 2,176 psi · 150 bar | 2,756 psi · 190 bar | +27% Puma 210 |
| Rear PTO speeds declared | 540/1000/540E rpm | 540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 19,908 lb · 9,030 kg | 18,078 lb · 8,200 kg | +10% DT-180 A |
| Maximum permissible mass declared | 30,865 lb · 14,000 kg | 26,455 lb · 12,000 kg | +17% DT-180 A |
| Wheelbase declared | 121.1 in · 3,075 mm | 113.5 in · 2,884 mm | +7% DT-180 A |
| Length declared | 206.3 in · 5,240 mm | 201.2 in · 5,110 mm | — |
| Width declared | 100.4 in · 2,550 mm | 84.1–133.7 in · 2,135–3,395 mm | differs |
| Ground clearance declared | 18.5 in · 470 mm | 17.7 in · 450 mm | — |
| Fuel tank declared | 697.4 qt · 660.0 L | 433.2 qt · 410.0 L | +61% DT-180 A |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-180 A sources
- Source: Traktorenlexikon, “AGCO DT 180 A”
Case-IH Puma 210 sources
- Source: Traktorenlexikon, “Case-IH Puma 210”
- Source: Traktorenlexikon, “New Holland T 6050 Elite”
- Source: OECD test report 2427, 2008