1 material differences · fewer than 12
Tractor oneAgco DT-1602002–2004No measured PTO figureTractor twoMassey Ferguson MF 82451999–2003No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their power is identical, with the same weight or the same engine, which usually means one machine sold under two names; any difference below comes from how each source describes it. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
1 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | DT-160 | MF 8245 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 159.8 hp | 160.0 hp | — |
| Engine declared | CUMMINS C-8.3 T | — | — |
| Displacement declared | 8.27 L | — | — |
| Maximum torque declared | 538 lb·ft · 729 N·m | — | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9 mph · 40 km/h | — |
| Clutch declared | Pedal operated wet VALEO multi-disc clutch | Wet multi-disc clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 30.8 gpm · 116.6 L/min | — | — |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 19,010 lb · 8,623 kg | 18,799 lb · 8,527 kg | — |
| Wheelbase declared | 121.0 in · 3,073 mm | 120.9 in · 3,070 mm | — |
| Length declared | 203.0 in · 5,156 mm | 201.2 in · 5,110 mm | — |
| Width declared | 98.2 in · 2,494 mm | 97.6 in · 2,480 mm | — |
| Ground clearance declared | 18.0 in · 457 mm | — | — |
| Fuel tank declared | 479.7 qt · 454.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-160 sources
- Source: Traktorenlexikon, “AGCO DT 160”
- Source: Traktorenlexikon, “White 8510”
Massey Ferguson MF 8245 sources
- Source: Traktorenlexikon, “Massey Ferguson MF 8245”