10 material differences · fewer than 12
Tractor oneAgco DT-1602002–2004No measured PTO figureTractor twoFendt 516 Variofrom 2012No measured PTO figure
Which should you choose?
Read our verdict on the DT-160 and the 516 Vario → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | DT-160 | 516 Vario | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 159.8 hp | 161 hp | — |
| Engine declared | CUMMINS C-8.3 T | Deutz TCD 4.1 L4-4V | differs |
| Displacement declared | 8.27 L | 4.04 L | +105% DT-160 |
| Maximum torque declared | 538 lb·ft · 729 N·m | 507 lb·ft · 687 N·m | +6% DT-160 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 31.1 mph · 50 km/h | +25% 516 Vario |
| Clutch declared | Pedal operated wet VALEO multi-disc clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 30.8 gpm · 116.6 L/min | — | — |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 19,010 lb · 8,623 kg | 14,110 lb · 6,400 kg | +35% DT-160 |
| Maximum permissible mass declared | — | 23,149 lb · 10,500 kg | — |
| Wheelbase declared | 121.0 in · 3,073 mm | 100.8 in · 2,560 mm | +20% DT-160 |
| Length declared | 203.0 in · 5,156 mm | 175.3 in · 4,453 mm | +16% DT-160 |
| Width declared | 98.2 in · 2,494 mm | 96.5 in · 2,451 mm | — |
| Ground clearance declared | 18.0 in · 457 mm | 20.2 in · 512 mm | +12% 516 Vario |
| Fuel tank declared | 479.7 qt · 454.0 L | 314.9 qt · 298 L | +52% DT-160 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-160 sources
- Source: Traktorenlexikon, “AGCO DT 160”
- Source: Traktorenlexikon, “White 8510”
Fendt 516 Vario sources
- Source: Traktorenlexikon, “Fendt 516 Vario”