10 material differences · fewer than 12
Tractor oneAGCO-ALLIS 98151994–1998No measured PTO figureTractor twoJohn Deere 82101999–2002No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1994–1998; 1999–2002). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 9815 | 8210 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 215.0 hp | 212.1 hp | — |
| Engine declared | DETROIT-DIESEL DT-530 | John Deere-PowerTech 6.081 HRW-13 | differs |
| Displacement declared | 8.71 L | 8.13 L | +7% 9815 |
| Maximum torque declared | 729 lb·ft · 989 N·m | 667 lb·ft · 905 N·m | +9% 9815 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Pedal-operated hydraulic wet John Deere multi-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | Closed centre | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 27.8 gpm · 105.2 L/min | 31.8 gpm · 120.4 L/min | +14% 8210 |
| Pressure declared | 2,944 psi · 203 bar | 3,379 psi · 233 bar | +15% 8210 |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 19,608 lb · 8,894 kg | 19,350 lb · 8,777 kg | — |
| Maximum permissible mass declared | — | 30,865 lb · 14,000 kg | — |
| Wheelbase declared | 115.0 in · 2,921 mm | 116.1 in · 2,950 mm | — |
| Length declared | 200.0 in · 5,080 mm | 216.0 in · 5,487 mm | +8% 8210 |
| Width declared | 98.0–115.0 in · 2,489–2,921 mm | 118.6–127.3 in · 3,012–3,233 mm | differs |
| Ground clearance declared | 22.5 in · 572 mm | 16.5 in · 420 mm | +36% 9815 |
| Turning radius, braked declared | 14.8 ft · 4.50 m | — | — |
| Fuel tank declared | 363.5 qt · 344.0 L | 540.0 qt · 511.0 L | +49% 8210 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 9815 sources
- Source: Traktorenlexikon, “AGCO-Allis 9815”
- Source: Traktorenlexikon, “AGCO-Allis 9675”
John Deere 8210 sources
- Source: Traktorenlexikon, “John Deere 8210”
- Source: OECD test report 1933, 2000