6 material differences · fewer than 12
Tractor oneAGCO-ALLIS 97751998–2001No measured PTO figureTractor twoFendt 820 Vario greentec2004–2011No measured PTO figure
Which should you choose?
Read our verdict on the 9775 and the 820 Vario greentec → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 9775 | 820 Vario greentec | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 204.1 hp | 204 hp | — |
| Engine declared | INTERNATIONAL-NAVISTAR DTA-530 | — | — |
| Maximum torque declared | — | 660 lb·ft · 895 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 31.1 mph · 50 km/h | differs |
| Clutch declared | Oil-cooled wet multi-plate clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Hydraulic control declared | — | Load sensing | — |
| Pressure declared | 3,046 psi · 210 bar | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 18,786 lb · 8,521 kg | 15,840 lb · 7,185 kg | +19% 9775 |
| Maximum permissible mass declared | — | 27,558 lb · 12,500 kg | — |
| Wheelbase declared | 112.5 in · 2,858 mm | 107.1 in · 2,720 mm | — |
| Length declared | 203.0 in · 5,156 mm | 187.1 in · 4,753 mm | +8% 9775 |
| Width declared | 98.2 in · 2,494 mm | 101.2 in · 2,570 mm | — |
| Ground clearance declared | 17.5 in · 445 mm | 22.3 in · 566 mm | +27% 820 Vario greentec |
| Fuel tank declared | 479.7 qt · 454.0 L | 359.3 qt · 340 L | +34% 9775 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 9775 sources
- Source: Traktorenlexikon, “AGCO-Allis 9775”
Fendt 820 Vario greentec sources
- Source: Traktorenlexikon, “Fendt 820 Vario greentec”