8 material differences · fewer than 12
Tractor oneAGCO-ALLIS 97651998–2001No measured PTO figureTractor twoDeutz-Fahr Agrotron 6190from 2013No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1998–2001; 2013–2013). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 9765 | Agrotron 6190 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 182.5 hp | 181 hp | — |
| Engine declared | INTERNATIONAL-NAVISTAR DT-530 | Deutz AG TCD 6.1 L06 4V | differs |
| Displacement declared | — | 6.06 L | — |
| Maximum torque declared | — | 605 lb·ft · 820 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | Oil-cooled wet multi-disc clutch | Electro-hydraulically operated multi-plate clutch, running in an oil bath | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | Open centre | differs |
| Pump flow declared | — | 21.9 gpm · 83 L/min | — |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 17,200 lb · 7,802 kg | 14,683 lb · 6,660 kg | +17% 9765 |
| Wheelbase declared | 112.5 in · 2,858 mm | 108.9 in · 2,767 mm | — |
| Length declared | 203.0 in · 5,156 mm | 189.2 in · 4,806 mm | +7% 9765 |
| Width declared | 98.2 in · 2,494 mm | 98.4 in · 2,500 mm | — |
| Ground clearance declared | 17.5 in · 445 mm | — | — |
| Fuel tank declared | 479.7 qt · 454.0 L | 264.2 qt · 250 L | +82% 9765 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 9765 sources
- Source: Traktorenlexikon, “AGCO-Allis 9765”
- Source: Traktorenlexikon, “AGCO-Allis 9755”
Deutz-Fahr Agrotron 6190 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 6190”
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 7250”