7 material differences · fewer than 12
Tractor oneAGCO-ALLIS 97551998–2001No measured PTO figureTractor twoFendt 516 Variofrom 2012No measured PTO figure
Which should you choose?
Read our verdict on the 9755 and the 516 Vario → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 9755 | 516 Vario | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 159.8 hp | 161 hp | — |
| Engine declared | INTERNATIONAL-NAVISTAR DT-530 | Deutz TCD 4.1 L4-4V | differs |
| Displacement declared | — | 4.04 L | — |
| Maximum torque declared | — | 507 lb·ft · 687 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 31.1 mph · 50 km/h | differs |
| Clutch declared | Oil-cooled wet multi-disc clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Hydraulic control declared | — | Load sensing | — |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 17,302 lb · 7,848 kg | 14,110 lb · 6,400 kg | +23% 9755 |
| Maximum permissible mass declared | — | 23,149 lb · 10,500 kg | — |
| Wheelbase declared | 112.5 in · 2,858 mm | 100.8 in · 2,560 mm | +12% 9755 |
| Length declared | 203.0 in · 5,156 mm | 175.3 in · 4,453 mm | +16% 9755 |
| Width declared | 98.2 in · 2,494 mm | 96.5 in · 2,451 mm | — |
| Ground clearance declared | — | 20.2 in · 512 mm | — |
| Fuel tank declared | 479.7 qt · 454.0 L | 314.9 qt · 298 L | +52% 9755 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 9755 sources
- Source: Traktorenlexikon, “AGCO-Allis 9755”
Fendt 516 Vario sources
- Source: Traktorenlexikon, “Fendt 516 Vario”