7 material differences · fewer than 12
Tractor oneAGCO-ALLIS 96951994–1998No measured PTO figureTractor twoDeutz-Fahr Agrotron 2102003–2004No measured PTO figure
Which should you choose?
Read our verdict on the 9695 and the Agrotron 210 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 9695 | Agrotron 210 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 195.3 hp | 195.4 hp | — |
| Engine declared | DETROIT-DIESEL DT-530 | Deutz BF6M 1013 FC | differs |
| Displacement declared | 8.71 L | 7.15 L | +22% 9695 |
| Maximum torque declared | 654 lb·ft · 887 N·m | 638 lb·ft · 865 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | Electro-hydraulically operated wet Funk multi-plate clutch type 9400 | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 20.6 gpm · 78.0 L/min | — | — |
| Pressure declared | 2,944 psi · 203 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 18,592 lb · 8,433 kg | 18,541 lb · 8,410 kg | — |
| Maximum permissible mass declared | — | 30,865 lb · 14,000 kg | — |
| Wheelbase declared | 116.5 in · 2,959 mm | 121.6 in · 3,089 mm | — |
| Length declared | 200.0 in · 5,080 mm | 196.9 in · 5,002 mm | — |
| Width declared | 98.0–115.0 in · 2,489–2,921 mm | 108.3 in · 2,750 mm | differs |
| Ground clearance declared | 22.5 in · 572 mm | 21.3 in · 540 mm | +6% 9695 |
| Turning radius, braked declared | 14.8 ft · 4.50 m | — | — |
| Fuel tank declared | 387.8 qt · 367.0 L | 581.2 qt · 550 L | +50% Agrotron 210 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 9695 sources
- Source: Traktorenlexikon, “AGCO-Allis 9695”
- Source: Traktorenlexikon, “AGCO-Allis 9675”
Deutz-Fahr Agrotron 210 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 210”
- Source: Traktorenlexikon, “Renault Atles 935 RZ”