10 material differences · fewer than 12

Tractor oneAGCO-ALLIS 96901994–1995No measured PTO figureTractor twoDeutz-Fahr Agrotron 2102003–2004No measured PTO figure

Which should you choose?

Read our verdict on the 9690 and the Agrotron 210 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

10 material differences · 3 fields identical or within 5%, which is not counted as material

AGCO-ALLIS 9690 and Deutz-Fahr Agrotron 210, field by field
Field9690Agrotron 210Gap
Engine
Engine power, claimed claimed195.3 hp195.4 hp—
Engine declaredK.H.D. BF6L 513 RCDeutz BF6M 1013 FCdiffers
Displacement declared9.57 L7.15 L+34% 9690
Maximum torque declared589 lb·ft · 798 N·m638 lb·ft · 865 N·m+8% Agrotron 210
Transmission
Top speed declared24.9 mph · 40 km/h24.9–31.1 mph · 40–50 km/hdiffers
Clutch declaredHydraulically operated wet FUNK multi-plate clutch——
Hydraulics & hitch
Hydraulic centre declaredClosed centre——
Hydraulic control declared—Load sensing—
Pump flow declared21.8 gpm · 82.5 L/min——
Pressure declared2,944 psi · 203 bar——
Three-point lift, at the coupling points declared8,173 lb · 3,707 kg23,149 lb · 10,500 kg+183% Agrotron 210
Rear PTO speeds declared1000 rpm540E/1000 rpmdiffers
Weight & dimensions
Unladen weight declared18,100 lb · 8,210 kg18,541 lb · 8,410 kg—
Maximum permissible mass declared—30,865 lb · 14,000 kg—
Wheelbase declared115.0 in · 2,921 mm121.6 in · 3,089 mm+6% Agrotron 210
Length declared200.0 in · 5,080 mm196.9 in · 5,002 mm—
Width declared96.0–140.0 in · 2,438–3,556 mm108.3 in · 2,750 mmdiffers
Ground clearance declared17.0 in · 432 mm21.3 in · 540 mm+25% Agrotron 210
Turning radius, braked declared14.6 ft · 4.45 m——
Fuel tank declared387.8 qt · 367.0 L581.2 qt · 550 L+50% Agrotron 210

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

AGCO-ALLIS 9690 sources

Source
  • Source: Traktorenlexikon, “AGCO-Allis 9690”
  • Source: Traktorenlexikon, “AGCO-Allis 9670”

Deutz-Fahr Agrotron 210 sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr Agrotron 210”
  • Source: Traktorenlexikon, “Renault Atles 935 RZ”