AGCO-ALLIS 9670 or DEUTZ-ALLIS 9170?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 9670 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9170 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The DEUTZ-ALLIS 9170 suits loader and hydraulic implement work better on this data: 18% (13.1 L/min / 3.5 gpm) more hydraulic flow.
- The AGCO-ALLIS 9670 suits road haulage better on this data: 33% (10.0 km/h / 6.2 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 9670 | 9170 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 130.2 kW (174.6 hp)Traktorenlexikon, “AGCO-Allis 9670” | 128 kW (172 hp)Traktorenlexikon, “Deutz-Allis 9170” | Not comparableNot comparable on power at the PTO shaft: the 9670 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9170 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 9670 and the 9170. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 9670 and the 9170. |
| Which pumps more oil for implements? | 73.8 L/min (19.5 gpm)Traktorenlexikon, “AGCO-Allis 9670” | 86.9 L/min (23.0 gpm)Traktorenlexikon, “Deutz-Allis 9170” | AheadThe DEUTZ-ALLIS 9170 has 18% more hydraulic flow (13.1 L/min / 3.5 gpm) than the AGCO-ALLIS 9670 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | — | 3,460 kg (7,628 lb)Traktorenlexikon, “Deutz-Allis 9170” | No figureNo call on three-point lift: no figure on record for the 9670. |
| Which is heavier, for traction? | 7,303 kg (16,100 lb)Traktorenlexikon, “AGCO-Allis 9670” | 7,094 kg (15,640 lb)Traktorenlexikon, “Deutz-Allis 9170” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 9670 and the 9170. |
| Which has the wider choice of gears? | 18Traktorenlexikon, “AGCO-Allis 9670” | 18Traktorenlexikon, “Deutz-Allis 9170” | EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 9670 and the 9170. |
| Which is faster on the road? | 40 km/h (24.9 mph)Traktorenlexikon, “AGCO-Allis 9670” | 30 km/h (18.6 mph)Traktorenlexikon, “Deutz-Allis 9170” | AheadThe AGCO-ALLIS 9670 has 33% more top speed (10.0 km/h / 6.2 mph) than the DEUTZ-ALLIS 9170 (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 1000 rpmTraktorenlexikon, “AGCO-Allis 9670” | 1000 rpmTraktorenlexikon, “Deutz-Allis 9170” | EvenEven on PTO speeds: the same speeds (1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “AGCO-Allis 9670” | independentTraktorenlexikon, “Deutz-Allis 9170” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “AGCO-Allis 9670” | Two-wheel or four-wheel driveTraktorenlexikon, “Deutz-Allis 9170” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1994–1995 | 1989–1990 | Ahead (a fact, not an advantage)The AGCO-ALLIS 9670 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The DEUTZ-ALLIS 9170 has 18% more hydraulic flow (13.1 L/min / 3.5 gpm) than the AGCO-ALLIS 9670 (both pump flow, as stated by the source).
- The AGCO-ALLIS 9670 has 33% more top speed (10.0 km/h / 6.2 mph) than the DEUTZ-ALLIS 9170 (both top speed forward, as stated by the source).
- The AGCO-ALLIS 9670 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
- Even on PTO speeds: the same speeds (1000 rpm).
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Not comparable on power at the PTO shaft: the 9670 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9170 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources