AGCO-ALLIS 9630 or Renault 145-54 TX?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 9630 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 145-54 TX has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 9630 | 145-54 TX | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 99.3 kW (133.2 hp)Traktorenlexikon, “AGCO-Allis 9630” | 99.4 kW (133.3 hp)Traktorenlexikon, “Renault 145-54 TE/TA/TS/TX/TZ R7942” | Not comparableNot comparable on power at the PTO shaft: the 9630 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 145-54 TX has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 9630 and the 145-54 TX. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 9630 and the 145-54 TX. |
| Which pumps more oil for implements? | 85.6 L/min (22.6 gpm)Traktorenlexikon, “AGCO-Allis 9630” | 41.1 L/min (10.9 gpm)Traktorenlexikon, “Renault 145-54 TE/TA/TS/TX/TZ R7942” | AheadThe AGCO-ALLIS 9630 has 108% more hydraulic flow (44.5 L/min / 11.8 gpm) than the Renault 145-54 TX (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 3,158 kg (6,962 lb)Traktorenlexikon, “AGCO-Allis 9630” | 8,850 kg (19,511 lb)Traktorenlexikon, “Renault 145-54 TE/TA/TS/TX/TZ R7942” | AheadThe Renault 145-54 TX has 180% more lift (5,692 kg / 12,549 lb) than the AGCO-ALLIS 9630 (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 6,714 kg (14,802 lb)Traktorenlexikon, “AGCO-Allis 9630” | 5,655 kg (12,467 lb)Traktorenlexikon, “Renault 145-54 TE/TA/TS/TX/TZ R7942” | Ahead (a fact, not an advantage)The AGCO-ALLIS 9630 is 19% heavier (1,059 kg / 2,335 lb) than the Renault 145-54 TX (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | 8,500 kg (18,739 lb)Traktorenlexikon, “Renault 145-54 TE/TA/TS/TX/TZ R7942” | No figureNo call on maximum permissible mass: no figure on record for the 9630. |
| Which has the wider choice of gears? | 18Traktorenlexikon, “AGCO-Allis 9630” | 16Traktorenlexikon, “Renault 145-54 TE/TA/TS/TX/TZ R7942” | EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 9630 and the 145-54 TX. |
| Which is faster on the road? | 40 km/h (24.9 mph)Traktorenlexikon, “AGCO-Allis 9630” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Renault 145-54 TE/TA/TS/TX/TZ R7942” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “AGCO-Allis 9630” | 540/1000 rpmTraktorenlexikon, “Renault 145-54 TE/TA/TS/TX/TZ R7942” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “AGCO-Allis 9630” | — | No figureNo call on PTO independence: not stated for the 145-54 TX. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “AGCO-Allis 9630” | 4WDTraktorenlexikon, “Renault 145-54 TE/TA/TS/TX/TZ R7942” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1993–1995 | 1989–1990 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The AGCO-ALLIS 9630 has 108% more hydraulic flow (44.5 L/min / 11.8 gpm) than the Renault 145-54 TX (both pump flow, as stated by the source).
- The Renault 145-54 TX has 180% more lift (5,692 kg / 12,549 lb) than the AGCO-ALLIS 9630 (both lift at the hitch ends, as stated by the source).
- The AGCO-ALLIS 9630 is 19% heavier (1,059 kg / 2,335 lb) than the Renault 145-54 TX (both unladen weight, as stated by the source).
- Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the 9630 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 145-54 TX has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources