AGCO-ALLIS 9630 or Agco RT-130 (Traktorenlexikon)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 9630 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the RT-130 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Agco RT-130 suits loader and hydraulic implement work better on this data: 39% (33.7 L/min / 8.9 gpm) more hydraulic flow and 123% (3,877 kg / 8,547 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 9630 | RT-130 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 99.3 kW (133.2 hp)Traktorenlexikon, “AGCO-Allis 9630” | 99 kW (133 hp)Traktorenlexikon, “AGCO RT 130” | Not comparableNot comparable on power at the PTO shaft: the 9630 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the RT-130 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 9630 and the RT-130. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 9630 and the RT-130. |
| Which pumps more oil for implements? | 85.6 L/min (22.6 gpm)Traktorenlexikon, “AGCO-Allis 9630” | 119.3 L/min (31.5 gpm)Traktorenlexikon, “AGCO RT 130” | AheadThe Agco RT-130 has 39% more hydraulic flow (33.7 L/min / 8.9 gpm) than the AGCO-ALLIS 9630 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 3,158 kg (6,962 lb)Traktorenlexikon, “AGCO-Allis 9630” | 7,035 kg (15,510 lb)Traktorenlexikon, “AGCO RT 130” | AheadThe Agco RT-130 has 123% more lift (3,877 kg / 8,547 lb) than the AGCO-ALLIS 9630 (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 6,714 kg (14,802 lb)Traktorenlexikon, “AGCO-Allis 9630” | 6,749 kg (14,879 lb)Traktorenlexikon, “AGCO RT 130” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 9630 and the RT-130. |
| Which has the wider choice of gears? | 18Traktorenlexikon, “AGCO-Allis 9630” | 18 to 32Traktorenlexikon, “AGCO RT 130” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 9630 and the RT-130. |
| Which is faster on the road? | 40 km/h (24.9 mph)Traktorenlexikon, “AGCO-Allis 9630” | 40 km/h (24.9 mph)Traktorenlexikon, “AGCO RT 130” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “AGCO-Allis 9630” | 540/1000 rpmTraktorenlexikon, “AGCO RT 130” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “AGCO-Allis 9630” | independentTraktorenlexikon, “AGCO RT 130” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “AGCO-Allis 9630” | Two-wheel or four-wheel driveTraktorenlexikon, “AGCO RT 130” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1993–1995 | 2002–2004 | Ahead (a fact, not an advantage)The Agco RT-130 is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Agco RT-130 has 39% more hydraulic flow (33.7 L/min / 8.9 gpm) than the AGCO-ALLIS 9630 (both pump flow, as stated by the source).
- The Agco RT-130 has 123% more lift (3,877 kg / 8,547 lb) than the AGCO-ALLIS 9630 (both lift at the hitch ends, as stated by the source).
- The Agco RT-130 is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Not comparable on power at the PTO shaft: the 9630 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the RT-130 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources