9 material differences · fewer than 12
Tractor oneAGCO-ALLIS 91901991–1992No measured PTO figureTractor twoDeutz-Fahr Agrotron 2052002–2003No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1991–1992; 2002–2003). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | 9190 | Agrotron 205 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 193.4 hp | 193 hp | — |
| Engine declared | K.H.D. BF6L 513 R-T | Deutz BF6M 1013 EC | differs |
| Displacement declared | 9.57 L | 7.15 L | +34% 9190 |
| Maximum torque declared | — | 639 lb·ft · 867 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | — | Hydraulically operated multi-plate clutch running in an oil bath | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 28.0 gpm · 105.9 L/min | — | — |
| Pressure declared | 3,771 psi · 260 bar | 2,901 psi · 200 bar | +30% 9190 |
| Rear PTO speeds declared | 1000 rpm | 540/750/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 16,601 lb · 7,530 kg | 20,503 lb · 9,300 kg | +24% Agrotron 205 |
| Wheelbase declared | 115.0 in · 2,921 mm | 121.7 in · 3,090 mm | +6% Agrotron 205 |
| Length declared | 200.0 in · 5,080 mm | 212.2 in · 5,390 mm | +6% Agrotron 205 |
| Width declared | 96.0 in · 2,438 mm | — | — |
| Ground clearance declared | 22.0 in · 559 mm | — | — |
| Turning radius, braked declared | 16.6 ft · 5.05 m | — | — |
| Fuel tank declared | 367.7 qt · 348.0 L | 401.5 qt · 380 L | +9% Agrotron 205 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 9190 sources
- Source: Traktorenlexikon, “AGCO-Allis 9190”
- Source: Traktorenlexikon, “Deutz-Allis 9170”
Deutz-Fahr Agrotron 205 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 205 MK3”
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 200”