8 material differences · fewer than 12
Tractor oneAGCO-ALLIS 87851998–1999No measured PTO figureTractor twoDeutz-Fahr Agrotron K 4302008–2013No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1998–1999; 2008–2013). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | 8785 | Agrotron K 430 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 110.5 hp | 110 hp | — |
| Engine declared | SISU-DIESEL 666 T | — | — |
| Displacement declared | 6.59 L | — | — |
| Maximum torque declared | — | 363 lb·ft · 492 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | Oil-cooled wet multi-disc clutch | Electro-hydraulic comfort clutch running in an oil bath | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 28.8 gpm · 109.0 L/min | — | — |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/540E/1000/1000E rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 10,840 lb · 4,917 kg | 9,789 lb · 4,440 kg | +11% 8785 |
| Maximum permissible mass declared | — | 17,637 lb · 8,000 kg | — |
| Wheelbase declared | 112.6 in · 2,860 mm | 95.2 in · 2,419 mm | +18% 8785 |
| Length declared | 176.0 in · 4,470 mm | 163.0 in · 4,139 mm | +8% 8785 |
| Width declared | 88.0 in · 2,235 mm | 95.7 in · 2,430 mm | +9% Agrotron K 430 |
| Ground clearance declared | — | 15.7 in · 400 mm | — |
| Turning radius, braked declared | — | 15.3 ft · 4.65 m | — |
| Fuel tank declared | 237.8 qt · 225.0 L | 190.2 qt · 180 L | +25% 8785 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 8785 sources
- Source: Traktorenlexikon, “AGCO-Allis 8785”
Deutz-Fahr Agrotron K 430 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron K 430”