9 material differences · fewer than 12
Tractor oneAGCO-ALLIS 87751998–1999No measured PTO figureTractor twoURSUS 1.002 / 1.0041984–2009No measured PTO figure
Which should you choose?
Read our verdict on the 8775 and the 1.002 / 1.004 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 8775 | 1.002 / 1.004 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 94.7 hp | 94.7 hp | — |
| Engine declared | SISU-DIESEL 666 | T.S.-MARTIN Z-8402 | differs |
| Displacement declared | — | 4.56 L | — |
| Maximum torque declared | — | 234 lb·ft · 317 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | Oil-cooled wet multi-disc clutch | Pedal-operated hydraulic dry single-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 29.8 gpm · 112.8 L/min | 8.5 gpm · 32.0 L/min | +253% 8775 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 9,359 lb · 4,245 kg | 7,716 lb · 3,500 kg | +21% 8775 |
| Wheelbase declared | 112.6 in · 2,860 mm | 93.9 in · 2,385 mm | +20% 8775 |
| Length declared | 176.0 in · 4,470 mm | 155.5 in · 3,950 mm | +13% 8775 |
| Width declared | 78.0 in · 1,981 mm | 81.9–94.1 in · 2,080–2,390 mm | differs |
| Ground clearance declared | — | 13.8 in · 350 mm | — |
| Turning radius, braked declared | — | 12.5 ft · 3.81 m | — |
| Fuel tank declared | 169.1 qt · 160.0 L | 132.1 qt · 125.0 L | +28% 8775 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 8775 sources
- Source: Traktorenlexikon, “AGCO-Allis 8775”
URSUS 1.002 / 1.004 sources
- Source: Traktorenlexikon, “Ursus 1002/1004”