6 material differences · fewer than 12
Tractor oneAGCO-ALLIS 87651998–1999No measured PTO figureTractor twoJohn Deere 2850 (A)1986–1994No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1998–1999; 1986–1994). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 8765 | 2850 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 84.9 hp | 84.9 hp | — |
| Engine declared | SISU-DIESEL 444 Y | John Deere 4.239 TL-007 | differs |
| Displacement declared | — | 3.92 L | — |
| Maximum torque declared | — | 239 lb·ft · 324 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | Oil-cooled wet multi-disc clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Closed centre | differs |
| Pump flow declared | — | 13.3 gpm · 50.5 L/min | — |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,616 lb · 3,908 kg | 7,099 lb · 3,220 kg | +21% 8765 |
| Maximum permissible mass declared | — | 13,184 lb · 5,980 kg | — |
| Wheelbase declared | 96.0 in · 2,438 mm | 89.2 in · 2,266 mm | +8% 8765 |
| Length declared | 161.0 in · 4,089 mm | 156.7 in · 3,980 mm | — |
| Width declared | 78.0 in · 1,981 mm | 80.9 in · 2,055 mm | — |
| Ground clearance declared | — | 24.8 in · 629 mm | — |
| Fuel tank declared | 147.9 qt · 140.0 L | 88.8–143.7 qt · 84.0–136.0 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 8765 sources
- Source: Traktorenlexikon, “AGCO-Allis 8765”
John Deere 2850 (A) sources
- Source: Traktorenlexikon, “John Deere 2850”