6 material differences · fewer than 12
Tractor oneAGCO-ALLIS 86101991–1997No measured PTO figureTractor twoLandini 12.500 (DT)1978–1990No measured PTO figure
Which should you choose?
Read our verdict on the 8610 and the 12.500 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 8 fields identical or within 5%, which is not counted as material
| Field | 8610 | 12.500 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 108.5 hp | 108.5 hp | — |
| Engine declared | S.L.H. 1000.6 A | Perkins A 6.354 | differs |
| Displacement declared | 6.00 L | 5.80 L | — |
| Maximum torque declared | 256 lb·ft · 347 N·m | 276 lb·ft · 374 N·m | +8% 12.500 (DT) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Pedal operated dry S.L.H. double clutch | Pedal-operated dry LUK dual clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 16.3 gpm · 61.7 L/min | 16.4 gpm · 62.0 L/min | — |
| Pressure declared | 2,176 psi · 150 bar | — | — |
| Rear PTO speeds declared | 540/540E/1000E/1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 10,869 lb · 4,930 kg | 10,604 lb · 4,810 kg | — |
| Maximum permissible mass declared | 16,535 lb · 7,500 kg | — | — |
| Wheelbase declared | 108.3 in · 2,750 mm | 111.8 in · 2,840 mm | — |
| Length declared | 179.5 in · 4,560 mm | 184.6 in · 4,690 mm | — |
| Width declared | 92.5 in · 2,350 mm | 97.2 in · 2,470 mm | — |
| Ground clearance declared | 19.3 in · 490 mm | 17.7 in · 450 mm | +9% 8610 |
| Turning radius, braked declared | 16.4 ft · 5.00 m | — | — |
| Fuel tank declared | 243.0 qt · 230.0 L | 190.2 qt · 180.0 L | +28% 8610 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 8610 sources
- Source: Traktorenlexikon, “AGCO-Allis 8610”
Landini 12.500 (DT) sources
- Source: Traktorenlexikon, “Landini 12500”
- Source: Traktorenlexikon, “Massey Ferguson MF 699”