9 material differences · fewer than 12
Tractor oneAGCO-ALLIS 76501991–1994No measured PTO figureTractor twoFendt 515 C1995–1999No measured PTO figure
Which should you choose?
Read our verdict on the 7650 and the 515 C → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 7650 | 515 C | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 147.0 hp | 148 hp | — |
| Engine declared | S.L.H. 1056 PS | — | — |
| Displacement declared | 6.24 L | — | — |
| Maximum torque declared | 359 lb·ft · 487 N·m | 423 lb·ft · 574 N·m | +18% 515 C |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | Pedal-operated dry S.L.H. double clutch | Wet multi-plate clutch as drive clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Hydraulic control declared | Load sensing | Load sensing | — |
| Pump flow declared | 17.7 gpm · 67.0 L/min | 24.6 gpm · 93.0 L/min | +39% 515 C |
| Pressure declared | 3,046 psi · 210 bar | 2,973 psi · 205 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 12,566 lb · 5,700 kg | 12,214 lb · 5,540 kg | — |
| Maximum permissible mass declared | 18,739 lb · 8,500 kg | — | — |
| Wheelbase declared | 114.2 in · 2,901 mm | 102.7 in · 2,609 mm | +11% 7650 |
| Length declared | 185.2 in · 4,704 mm | 176.4 in · 4,480 mm | — |
| Width declared | 86.0 in · 2,184 mm | 96.1 in · 2,440 mm | +12% 515 C |
| Ground clearance declared | 20.4 in · 518 mm | 22.7 in · 576 mm | +11% 515 C |
| Turning radius, braked declared | 17.2 ft · 5.25 m | 16.1 ft · 4.90 m | +7% 7650 |
| Fuel tank declared | 221.9 qt · 210.0 L | 221.9 qt · 210 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 7650 sources
Source
- Source: Traktorenlexikon, “AGCO-Allis 7650”
Fendt 515 C sources
Source
- Source: Traktorenlexikon, “Fendt Favorit 515 C”