10 material differences · fewer than 12
Tractor oneAGCO-ALLIS 56801991–1997No measured PTO figureTractor twoSAME Silver 80 (DT)1995–2004No measured PTO figure
Which should you choose?
Read our verdict on the 5680 and the Silver 80 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | 5680 | Silver 80 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 78.9 hp | 78.9 hp | — |
| Engine declared | S.L.H. 1000.4 A-1 | SAME-DEUTZ-FAHR 1000.4 A 4 | differs |
| Displacement declared | 4.00 L | 4.00 L | — |
| Maximum torque declared | 193 lb·ft · 261 N·m | 180 lb·ft · 244 N·m | +7% 5680 |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9 mph · 40 km/h | differs |
| Clutch declared | Pedal-operated dry SAME double clutch | Pedal-operated dry single-plate clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 10.7 gpm · 40.5 L/min | 10.5 gpm · 39.8 L/min | — |
| Pressure declared | 3,046 psi · 210 bar | 3,118 psi · 215 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/540E/1000E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,669 lb · 3,025 kg | 7,937 lb · 3,600 kg | +19% Silver 80 (DT) |
| Maximum permissible mass declared | 11,464 lb · 5,200 kg | 13,228 lb · 6,000 kg | +15% Silver 80 (DT) |
| Wheelbase declared | 92.9 in · 2,360 mm | 97.2 in · 2,470 mm | — |
| Length declared | 154.3 in · 3,919 mm | 161.6 in · 4,105 mm | — |
| Width declared | 76.4–97.0 in · 1,941–2,464 mm | 72.4–101.6 in · 1,840–2,580 mm | differs |
| Ground clearance declared | 19.7 in · 500 mm | 20.3 in · 515 mm | — |
| Turning radius, braked declared | 9.2 ft · 2.80 m | 10.5 ft · 3.20 m | +14% Silver 80 (DT) |
| Fuel tank declared | 83.5 qt · 79.0 L | 158.5 qt · 150.0 L | +90% Silver 80 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 5680 sources
- Source: Traktorenlexikon, “AGCO-Allis 5680”
SAME Silver 80 (DT) sources
- Source: Traktorenlexikon, “SAME Silver 80”