8 material differences · fewer than 12
Tractor oneAGCO-ALLIS 56701991–1999No measured PTO figureTractor twoFord 5030 (A)1992–1996No measured PTO figure
Which should you choose?
Read our verdict on the 5670 and the 5030 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 9 fields identical or within 5%, which is not counted as material
| Field | 5670 | 5030 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 69.1 hp | — |
| Engine declared | S.L.H. 1000.4 A | Ford C 256 CID-NA | differs |
| Displacement declared | 4.00 L | 4.19 L | — |
| Maximum torque declared | 176 lb·ft · 239 N·m | 176 lb·ft · 239 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | Pedal-operated dry SAME double clutch | Pedal operated dry AP single plate clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 9.5 gpm · 36.0 L/min | 9.2 gpm · 34.8 L/min | — |
| Pressure declared | 1,740 psi · 120 bar | 1,508 psi · 104 bar | +15% 5670 |
| Three-point lift, at the coupling points declared | 6,504 lb · 2,950 kg | 4,381 lb · 1,987 kg | +48% 5670 |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,195 lb · 2,810 kg | 6,217 lb · 2,820 kg | — |
| Maximum permissible mass declared | 9,700 lb · 4,400 kg | — | — |
| Wheelbase declared | 91.3 in · 2,319 mm | 89.6 in · 2,276 mm | — |
| Length declared | 151.6 in · 3,851 mm | 143.7 in · 3,650 mm | +6% 5670 |
| Width declared | 73.2–93.5 in · 1,859–2,375 mm | 72.2 in · 1,835 mm | differs |
| Ground clearance declared | 17.7 in · 450 mm | 13.9 in · 353 mm | +27% 5670 |
| Turning radius, braked declared | 9.2 ft · 2.80 m | — | — |
| Fuel tank declared | 71.9 qt · 68.0 L | 69.4 qt · 65.7 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 5670 sources
- Source: Traktorenlexikon, “AGCO-Allis 5670”
Ford 5030 (A) sources
- Source: Traktorenlexikon, “Ford 5030”