9 material differences · fewer than 12
Tractor oneAGCO-ALLIS 56501994–1999No measured PTO figureTractor twoSteyr 948 (a)1992–1996No measured PTO figure
Which should you choose?
Read our verdict on the 5650 and the 948 (a) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 5650 | 948 (a) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47.3 hp | 47.3 hp | — |
| Engine declared | S.L.H. 1000.3 A | Steyr WD 308.85 | differs |
| Displacement declared | 3.00 L | 2.36 L | +27% 5650 |
| Maximum torque declared | 123 lb·ft · 167 N·m | 108 lb·ft · 147 N·m | +14% 5650 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Dry SAME double clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 8.7 gpm · 33.0 L/min | — | — |
| Pressure declared | 1,305 psi · 90 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,530 lb · 2,055 kg | 5,093 lb · 2,310 kg | +12% 948 (a) |
| Maximum permissible mass declared | — | 7,716 lb · 3,500 kg | — |
| Wheelbase declared | 77.8 in · 1,976 mm | 77.5 in · 1,968 mm | — |
| Length declared | 133.0 in · 3,378 mm | 129.5 in · 3,290 mm | — |
| Width declared | 66.7–82.5 in · 1,694–2,096 mm | 68.5 in · 1,740 mm | differs |
| Ground clearance declared | 19.7 in · 500 mm | 17.5 in · 445 mm | +12% 5650 |
| Turning radius, braked declared | 8.9 ft · 2.70 m | 10.5 ft · 3.19 m | +18% 948 (a) |
| Fuel tank declared | 60.2 qt · 57.0 L | 56.0 qt · 53.0 L | +8% 5650 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 5650 sources
- Source: Traktorenlexikon, “AGCO-Allis 5650”
Steyr 948 (a) sources
- Source: Traktorenlexikon, “Steyr 948”