Fiat 1300 Super (DT) (Fiat) or Steyr 8165 a?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 1300 Super (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 8165 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Steyr 8165 a suits loader and hydraulic implement work better on this data: 10% (4.7 L/min / 1.2 gpm) more hydraulic flow.
  • The Steyr 8165 a suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Fiat 1300 Super (DT) (Fiat) and Steyr 8165 a, with the call on each
Question1300 Super (DT)8165 aCall
Which puts more power through the PTO shaft?110.3 kW (147.9 hp)Traktorenlexikon, “Fiat 1300-S/1300-S DT”110.4 kW (148.0 hp)Traktorenlexikon, “Steyr 8165”Not comparableNot comparable on power at the PTO shaft: the 1300 Super (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 8165 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 1300 Super (DT) and the 8165 a.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 1300 Super (DT) and the 8165 a.
Which pumps more oil for implements?45.5 L/min (12.0 gpm)Traktorenlexikon, “Fiat 1300-S/1300-S DT”50.2 L/min (13.3 gpm)Traktorenlexikon, “Steyr 8165”AheadThe Steyr 8165 a has 10% more hydraulic flow (4.7 L/min / 1.2 gpm) than the Fiat 1300 Super (DT) (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?4,469 kg (9,852 lb)Traktorenlexikon, “Fiat 1300-S/1300-S DT”6,020 kg (13,272 lb)Traktorenlexikon, “Steyr 8165”Not comparableNot comparable on three-point lift: the 1300 Super (DT): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Fiat 1300-S/1300-S DT”); the 8165 a: lift through the full range at an unstated point, as stated by the source (Traktorenlexikon, “Steyr 8165”) — not the same quantity, basis and condition.
Which is heavier, for traction?5,060 kg (11,155 lb)Traktorenlexikon, “Fiat 1300-S/1300-S DT”5,575 kg (12,291 lb)Traktorenlexikon, “Steyr 8165”Ahead (a fact, not an advantage)The Steyr 8165 a is 10% heavier (515 kg / 1,135 lb) than the Fiat 1300 Super (DT) (both unladen weight, as stated by the source).
Which may carry more ballast and load?8,500 kg (18,739 lb)Traktorenlexikon, “Steyr 8165”No figureNo call on maximum permissible mass: no figure on record for the 1300 Super (DT).
Which has the wider choice of gears?12 to 16Traktorenlexikon, “Fiat 1300-S/1300-S DT”12 to 36Traktorenlexikon, “Steyr 8165”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 1300 Super (DT) and the 8165 a.
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “Fiat 1300-S/1300-S DT”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Steyr 8165”AheadThe Steyr 8165 a has 20% more top speed (5.0 km/h / 3.1 mph) than the Fiat 1300 Super (DT) (both top speed forward, as stated by the source).
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Fiat 1300-S/1300-S DT”1000 rpmTraktorenlexikon, “Steyr 8165”AheadThe Fiat 1300 Super (DT) offers 540 rpm at the PTO, which the Steyr 8165 a does not (as stated by the sources).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Fiat 1300-S/1300-S DT”independentTraktorenlexikon, “Steyr 8165”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 1300-S/1300-S DT”4WDTraktorenlexikon, “Steyr 8165”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1978–19811986–1993Ahead (a fact, not an advantage)The Steyr 8165 a is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Steyr 8165 a has 10% more hydraulic flow (4.7 L/min / 1.2 gpm) than the Fiat 1300 Super (DT) (both pump flow, as stated by the source).
  • The Steyr 8165 a is 10% heavier (515 kg / 1,135 lb) than the Fiat 1300 Super (DT) (both unladen weight, as stated by the source).
  • The Steyr 8165 a has 20% more top speed (5.0 km/h / 3.1 mph) than the Fiat 1300 Super (DT) (both top speed forward, as stated by the source).
  • The Fiat 1300 Super (DT) offers 540 rpm at the PTO, which the Steyr 8165 a does not (as stated by the sources).
  • The Steyr 8165 a is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO independence: every PTO is independent.
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on power at the PTO shaft: the 1300 Super (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 8165 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • Not comparable on three-point lift: the 1300 Super (DT): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Fiat 1300-S/1300-S DT”); the 8165 a: lift through the full range at an unstated point, as stated by the source (Traktorenlexikon, “Steyr 8165”) — not the same quantity, basis and condition.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources