Deutz-Fahr AgroStar 6.38 or SAME Antares 110?
Which should you choose?
On performance, every comparable figure that differs favours the Deutz-Fahr AgroStar 6.38: three-point lift and maximum permissible mass. On features, the SAME Antares 110 is ahead on PTO speeds.
- The SAME Antares 110 suits PTO-driven implements (mowers, balers, pumps) better on this data: offers 540 rpm.
- The Deutz-Fahr AgroStar 6.38 suits loader and hydraulic implement work better on this data: 25% (1,310 kg / 2,888 lb) more three-point lift.
- The Deutz-Fahr AgroStar 6.38 suits road haulage better on this data: 13% (1,000 kg / 2,205 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | AgroStar 6.38 | Antares 110 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 76 kW (102 hp)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 75.8 kW (101.6 hp)Traktorenlexikon, “SAME Antares 110” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the AgroStar 6.38 and the Antares 110. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the AgroStar 6.38 and the Antares 110. |
| Which pumps more oil for implements? | 58.0 L/min (15.3 gpm)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 61.7 L/min (16.3 gpm)Traktorenlexikon, “SAME Antares 110” | EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which lifts more on the three-point hitch? | 6,500 kg (14,330 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 5,190 kg (11,442 lb)Traktorenlexikon, “SAME Antares 110” | AheadThe Deutz-Fahr AgroStar 6.38 has 25% more lift (1,310 kg / 2,888 lb) than the SAME Antares 110 (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 4,640 kg (10,229 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 4,855 kg (10,703 lb)Traktorenlexikon, “SAME Antares 110” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 8,500 kg (18,739 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 7,500 kg (16,535 lb)Traktorenlexikon, “SAME Antares 110” | AheadThe Deutz-Fahr AgroStar 6.38 has 13% higher maximum permissible mass (1,000 kg / 2,205 lb) than the SAME Antares 110 (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 40 to 48Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 24 to 48Traktorenlexikon, “SAME Antares 110” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | YesTraktorenlexikon, “Deutz-Fahr AgroStar 6.38” | — | No figureNo call on a creeper range: not stated for the Antares 110. |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 40 km/h (24.9 mph)Traktorenlexikon, “SAME Antares 110” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 1000 rpmTraktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 540/540E/1000E/1000 rpmTraktorenlexikon, “SAME Antares 110” | AheadThe SAME Antares 110 offers 540 rpm at the PTO, which the Deutz-Fahr AgroStar 6.38 does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Fahr AgroStar 6.38” | — | No figureNo call on PTO independence: not stated for the Antares 110. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 4WDTraktorenlexikon, “SAME Antares 110” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1993–1995 | 1991–1996 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Deutz-Fahr AgroStar 6.38 has 25% more lift (1,310 kg / 2,888 lb) than the SAME Antares 110 (both lift at the hitch ends, as stated by the source).
- The Deutz-Fahr AgroStar 6.38 has 13% higher maximum permissible mass (1,000 kg / 2,205 lb) than the SAME Antares 110 (both maximum permissible mass, as stated by the source).
- The SAME Antares 110 offers 540 rpm at the PTO, which the Deutz-Fahr AgroStar 6.38 does not (as stated by the sources).
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources