Case-IH CS-75 A or Deutz-Fahr Agroplus 75?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the CS-75 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Agroplus 75 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Deutz-Fahr Agroplus 75 suits road haulage better on this data: 38% (1,700 kg / 3,748 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | CS-75 A | Agroplus 75 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 55.2 kW (74.0 hp)Traktorenlexikon, “Case-IH CS75a” | 55.2 kW (74.0 hp)Traktorenlexikon, “Deutz-Fahr Agroplus 75” | Not comparableNot comparable on power at the PTO shaft: the CS-75 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Agroplus 75 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the CS-75 A and the Agroplus 75. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the CS-75 A and the Agroplus 75. |
| Which pumps more oil for implements? | 41.4 L/min (10.9 gpm)Traktorenlexikon, “Case-IH CS75a” | — | No figureNo call on hydraulic flow: no figure on record for the Agroplus 75. |
| Which lifts more on the three-point hitch? | — | 3,600 kg (7,937 lb)Traktorenlexikon, “Deutz-Fahr Agroplus 75” | No figureNo call on three-point lift: no figure on record for the CS-75 A. |
| Which is heavier, for traction? | 3,100 kg (6,834 lb)Traktorenlexikon, “Case-IH CS75a” | 3,430 kg (7,562 lb)Traktorenlexikon, “Deutz-Fahr Agroplus 75” | Ahead (a fact, not an advantage)The Deutz-Fahr Agroplus 75 is 11% heavier (330 kg / 728 lb) than the Case-IH CS-75 A (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 4,500 kg (9,921 lb)Traktorenlexikon, “Case-IH CS75a” | 6,200 kg (13,669 lb)Traktorenlexikon, “Deutz-Fahr Agroplus 75” | AheadThe Deutz-Fahr Agroplus 75 has 38% higher maximum permissible mass (1,700 kg / 3,748 lb) than the Case-IH CS-75 A (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 16 to 32Traktorenlexikon, “Case-IH CS75a” | 30Traktorenlexikon, “Deutz-Fahr Agroplus 75” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the CS-75 A and the Agroplus 75. |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Case-IH CS75a” | 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr Agroplus 75” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540 rpm / 1000 rpmTraktorenlexikon, “Case-IH CS75a” | 540/1000 rpmTraktorenlexikon, “Deutz-Fahr Agroplus 75” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | — | — | No figureNo call on PTO independence: not stated for the CS-75 A and the Agroplus 75. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Case-IH CS75a” | 2WD / 4WDTraktorenlexikon, “Deutz-Fahr Agroplus 75” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1994–2001 | 1997–2005 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Deutz-Fahr Agroplus 75 is 11% heavier (330 kg / 728 lb) than the Case-IH CS-75 A (both unladen weight, as stated by the source).
- The Deutz-Fahr Agroplus 75 has 38% higher maximum permissible mass (1,700 kg / 3,748 lb) than the Case-IH CS-75 A (both maximum permissible mass, as stated by the source).
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the CS-75 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Agroplus 75 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources